Chuck controller required additionally

Application:
Suitable for high precision angle grinding of molds and jigs.

Features:
The gage block can be set on either the right side (R) or left side (L) to meet the rotating direction of the grinding wheel of the grinder.
The chuck can be smoothly tilted and easily operated.
An angle can be set finely by one try with the clamp system.
The position can be changed and secured by pulling the lever in the axial direction.
When the dustproof cover of the gage block is opened beyond about 60 degrees, it is locked to facilitate set-up and cleaning.

Chuck controller required additionally

Application:
Constructed to enable real-time internal cooling of heat generated when power is applied to the electromagnet, making these models suitable for higher precision grinding requirements.

Features:
Change in precision is minimized by feeding the coolant inside chuck to cool the coil and prevent temperature rise. Water flow 2 to 4 L/min.
The mechanical functions and features are almost the same as those of Model SBE chucks.

Chuck controller required additionally

Application:
These chucks are recommended for angle grinding of molds and jigs. Since magnetization is carried out by momentary power application, almost no heat is generated to make this model suitable for high precision grinding.

Features:
Electricity is applied momentarily. No electricity is required to maintain the holding power during grinding, thus saving energy.
The holding power is maintained in the event of power failure during grinding, enhancing safety.
The mechanical functions and the features are almost the same as those of Model SBE.

Application:
Suitable for grinding molds and jigs including relatively small and thin ones that require high precision.

Features:
No electricity is needed, thus no heat is generated.
The mechanical functions and the features are almost the same as those of Model SBE.

Effective area of double type sine bar chuck is enlarged by employing the thin type permanent magnetic chuck. This increases the range of types usable by tilting works in length, breadth or composite angle.

Features:

*Each part is designed to withstand the use for longer period in high precision finish within 0.007 mm same as single type.

Application:
Flat type for wide range of uses in height so thin as 81mm~106 mm. This single type chuck is finished in high precision within 5 micron by mounting thin type permanent magnetic chuck.

Entire sine bar section is made of special steel and ground in precision after hardening it.

High precision grinding and measurement is ensured for longer periods due to lapping finish of principal sections.

Features:
*New type with thin permanent magnetic chuck.

*Easy to use and a large effective area is provided for machining the works.

Application:
Designed for easy use in mold-grinding and angle measurement of small works.

Features:
*Compact and simple in construction for easy handling.

*The shaft can be secured so as to use it for grinding operation.

*Usable as sine bar by removing the pemranent magnetic chuck from chuck base.
Eesy to clean up.

Two types are available such as lengthy type (Model SBP-R713S) and breadthy type (Model SBP-R713L) as seen to the tilting angle.

Excellent precision and durability similar to thin type permanent magnetic sine bar chuck, but overall height is slightly higher.

Application:
Easily usable for angle-grinding for high precision on the mold grinder, etc.

Features:
*Thin type permanent magnetic chuck is applied.

*Polar pitch on the work face is shortened to 1.5 mm from conventional 10 mm so as to meet the grinding work of wide range from small pieces to thick work.