Application:

These demagnetizers produce an alternating magnetic field on the surface by use of an AC power source through which works are passed to remove the magnetism remaining on their surface.

Features:

*Thick work can be demagnetized effectively by passing its front and rear side over the demagnetizer.

*These demagnetizers are very powerful and can demagnetize steel materials such as high speed steel, bearing steel, nickel-chrome steel, spring steel, die steel, etc. which are difficult to demagnetize by standard demagnetizers (since these steels have the property similar to magnetic steel which retains residual magnetism and is hard to remove).

*These demagnetizers have good heat radiation and can withstand continuous power application.

Application:

This is a unit to produce attenuating alternate magnetic field on the surface to remove residual magnetism in works and tools.

Features:

*Normal table type demagnetizers require the physical movement of the works or the demagnetizer for separation of relative positions at a certain distance in order to obtain the attenuation effect of the alternating field required for demagnetization. With this stationary type demagnetizer, however, the programmed attenuating alternating field acts on the table so that magnetized works can be demagnetized only by placing them on it.

*This is of separate type that protects the electrical components from molecular friction heat due to the alternating field and power application.

*Model KMDE-M is finished with stainless steel and Model E is finished with painting.

Application:

Suitable for demagnetizing tools such as drills, cutting tools, cutters and magnetized slide calipers.

They can also be used for demagnetizing a part of large steel plates.

Features:

*Compact and handy.

[How to use]

*Demagnetizer is turned on while pressing the pushbutton switch and turned off when you release it.

*The button must be pressed on during demagnetizing operation.

*Turn it off when the demagnetizer is more than 100 mm away from the demagnetizing work.

*Working rate: 70% ED (electrifying it 7 minutes and pausing for 3 minutes).

Application:

These demagnetizers produce a strong magnetic filed on the surface by use of an AC power source to demagnetize works on a belt which runs over close to the surface.

Features:

*They are water-proofed and will not fail when wetted by cutting oil or cooling water.

*They can be incorporated in belt type grinders or other automatic and continuous grinders.

*The very strong demagnetizing force produced provides some margin on gap width on the surface to allow a belt conveyor to run over the working face.

[Precautions for use]

*Cool them always by pouring water, 50% rated when you use them in dry area (electrifying them for 20 minutes and turning off for 20minutes.)

Application:

These demagnetizers can meet such demagnetizing needs as passing a bucket containing a large number of small works and being incorporated in a line for continuous demagnetizing by conveyor transportation.

Various sizes are available to meet such requirements. They can also be used to demagnetize long works and irregularly shaped works.

Features:

*The good heat radiation design enables continuous operation.

*A uniform demagnetizing area can be obtained.

*Almost uniform demagnetization can act on the whole periphery of passing workpieces.