Application:

*Can be used to hold down drawings, rules and paper patterns.

*The models with tapped holes on the back can be used widely by installing them on jigs.

*Can be incorporated in press dies.

*Can hold workpieces during wire cutting.

Features:

*Four specifications, OD tolerance, plating, painting and peripheral knurling, are available for selection according to applications.

*When suitable OD “h” tolerances are selected, they can be incorporated in dies.

*When tapped holes are made on the back, they can be used in various applications.

Application:

This holder is to be used as a jig.

This holder is to be used for the transporting ligher work pieces in the manufacturing line, etc.

Features:

*This holder can be easily attached to any place, since its top end is threaded.

*This holder can be attached to the place where tap hole cannot be drilled by combining it with accessory plate or in case of the same with plate type.

*Since this holder is plated with nickel, it can be used under various circumstances.

Specifications:

Facial Treatment : MFNiII-b3

Application:

Most suitable for holding welding cable,for putting fixures in order at theworking site of shipbuilding, iron and steel manufacturing, birdge building, canneries and similar operations.

Features:

*Strong holding power capable of destacking stacked thin iron sheets.

*Lateral sliding resistance of 80N(8kgf)gives the hanger good holding power.

Application:

Powerful magnetic hanger-holder most suitable for cable arrangement and provisional wiring work inside the premises. Applicable to wide range of uses as hanger, since it attracts powerfully sheet, steel locker, refrigerator, etc.

Application:

Versatile holders having four attractive faces to meet various applications.
These holders also have threaded holes to enable fixtures to be mounted for connection.

Application:

The magpad is a device to prevent wire breakage by heat due to aerial discharge. It protects wire electrodes of wire electric discharge machines from separation of cooling liquid which is likely to occur at the start of discharging.

This magped can also be used to prevent dislocation or dropping of cut works at the start or end of cutting.

Features:

*The magpad is made of transparent acrylic plate incorporating powerful magnets. Having a strong holding power, it enables setting wire while monitoring its position.

*No mechanical clamp is required. Attaching and detaching can be done efficiently and without a fear of damaging the work.

*Various models are availables to suit any work configuration.

*There is no possibility of rusting and the magnetic force is semi-permanent. The magpad withstands repeated use and thereforce is very economical.

Application:

Suitable as holding tools for tentative installation and tack welding on such work sites of construction, bridge, ship building and piping.

Features:

*There are three faces where additional machining (such as drilling) can be done. (Refer to the dimension drawing)

*The exterior is made of aluminum to prevent adhesion of iron powder to the top and side faces.

*Model WK-TP has a construction that is highly resistant to heat.