Application:

These holders can be used for tentative holding and tentative assembly during welding work. They have a strong work holding power.

Features:

*The holding angle can be set to 15°, 45°, 60°, 90°, 105°and 120°.

*ON-OFF switchover function provided.

*The holding power on steel plate is about the same as the double face holding of KM-S9 and S12. At angles other than 105°, the holding power in double face attraction will drop little.

Application:

These holders are used for tack welding and tentative assembly during welding and assembly work. They can be used in wide applications as they hold round pipes and round steel.

Features:

*The holding angle can be set to 45°, 90°and 135°.

*Compact and handy. Lower cost and simpler than the hexagonal holder KM-S.

*The concave attractive face can hold certain round steel.

Application:

These holders provide a strong holding power for tentative holding during welding and tentative assembly. These holders can also be used as a block.

Features:

*The holding angle can be set to 45°, 90°and 135°.

*The small type is equipped with a pushbutton and the large type with a rotary handle for turning on and off the magnetic force.

*The V-groove enables the work attractive face to be located not only on the flat surface but on the curved surface.

Application:

This clamp can be used for tentative holding and tentative assembly during welding to hold workpieces strongly. It can also be used as a block.

Features:

*The V-groove on the attractive face enables this clamp to be used for materials having curved surfaces such as round steel and pipe in addition to flat materials.

*ON-OFF switchover function provided.

*Holding angle 90°only.

Application:

Suitable for tentative holding during drilling and assembly.

Features:

*Two magnets as a pair for easy angle setting.

*An angle scale provided. (KM-12W)

*The magnetic force can be turned on and off by operating the lever. (KM-12W)

*The V-groove allows the holder to be attached to certain poles and curved surfaces in addition to the flat surface. (KM-12W).

Application:

Suitable for mating and keeping stationary jointing parts of iron sheets and members during welding work.

Features:

*Powerful holding by use of a high performance permanent magnet.

*Both inside and outside welding is possible. (Note 1)

*Any desired holding angle can be set in a range of 45°and 135°(angle scale provided).

*ON/OFF switchover function and V-groove provided.

Application:

Suitable for mating and keeping stationary jointing parts of iron sheets and members during welding work.

Features:

*Powerful holding by use of a high performance permanent magnet.

*Any desired holding angle can be set in a range of 30°and 90°(angle scale provided).

*Angle adjustment with a handle.

*ON-OFF switchover function provided.